After much lolligagging, all the parts are wired up and tested with a 775 gear reduction motor. For the overly large hole I cut into the top for the LCD, I 3D printed a bezel. Next step is to build…
After much lolligagging, all the parts are wired up and tested with a 775 gear reduction motor. For the overly large hole I cut into the top for the LCD, I 3D printed a bezel. Next step is to build…
From a recent drive-by while on vacation heading south I drove by this is the house in Salem, Oregon which belonged to my great uncle Clayton whom my middle name was derived from. In the garage was where I got…
This is the first installment into a series of craft ideas which can be created from a pen blank. The Needle ‘n Thread case is made with a hollow spool section to contain a selection of sewing needles. In rifling…
You must be logged in to post a comment.